Failback Job Wizard for Microsoft Hyper-V: Networks

When the replica network address differs from the network address where the source VMs are deployed, your failback job needs a relation between these networks to be performed successfully. This relation is called a network mapping.

To map source VM virtual networks to the appropriate target virtual networks, please do the following on the Networks page of the wizard:

1. Select Enable network mapping.

2. The Network Mappings section opens. You have the following options:

   • Create a new network mapping:

     1. Click Create new mapping.

     2. The Add New Network Mapping dialog box opens. Choose a source network and a target network and click Save.

        

   • Add an existing network mapping:

     1. Click Add existing mapping.

     2. The Network Mappings dialog opens. Choose an appropriate network mapping and close the dialog box.

        

   • Edit an existing network mapping:

     1. Hover over the required item in the Network Mappings list.

     2. A toolbar with icons opens to the right of the item. Click the Edit icon.

     3. The Edit Network Mapping dialog opens. Choose an appropriate item from the Target network drop-down list and click Save.

        

   • Delete an existing mapping:

     1. Hover over the required item in the Network Mappings list.

     2. A toolbar with icons opens to the right of the item. Click the Delete icon.

        

   • To leave the list of existing network mappings intact, go to the next page of the wizard.

3. Click Next to go to the next page of the wizard.