Installing on NETGEAR ReadyNAS via Available Apps

Important

This method is not possible for ReadyNAS OS 6.10.10. To use this method for installing NAKIVO Backup & Replication, you need to use or downgrade to ReadyNAS OS 6.10.9.

Before you begin installing NAKIVO Backup & Replication or NAKIVO Transporter on a NETGEAR ReadyNAS device, please check if your NETGEAR ReadyNAS model is supported.

To install NAKIVO Backup & Replication or NAKIVO Transporter, take the following steps:

  1. Open the NETGEAR ReadyNAS Admin Page in your browser by entering the IP address of your NAS.

  2. Go to Apps -> Available Apps.

  3. Find NAKIVO Backup & Replication or NAKIVO Transporter in the list of available applications. Alternatively, you can enter NAKIVO to the filtering box in the upper left corner of the Admin Page.

  4. Click the Install button below the corresponding item.

    Note

    Make sure that only one instance of the NAKIVO solution - either Full Product or Transporter-only - is installed on the device concurrently. Having both products installed at once may lead to incorrect operation.

  5. Wait until the installation is completed.

By default, the NAKIVO Backup & Replication interface is available at the IP address of your NETGEAR ReadyNAS on the port 4443: https://<IP_address_of_ NETGEAR_ReadyNAS>:4443.

Refer to Getting Started to know how to continue working with NAKIVO Backup & Replication.