Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

NAKIVO Backup & Replication cannot perform VMware VM backup if the Transporter is installed on Ubuntu 16.04+ and the SAN Transport mode is selected.

Background

NAKIVO Backup & Replication can read data directly from VMware VM disks located on SAN, bypassing the network, which can significantly increase job performance. This is achieved with VMware's Direct SAN Access technology, which enables accessing source VM disks directly from the SAN. In order for the Direct SAN Access to work, the source Transporter (the one reading data from the source VM) should have access to the SAN. Additionally, if you are using an iSCSI SAN, you need to configure the iSCSI initiator on the machine where you plan to install the source Transporter (for more information, refer to Transporter Deployment for SAN Access).

...

If the NAKIVO Backup & Replication Transporter was already installed on Ubuntu 16.04+, install AppArmor service using the command above and re-run Transporter installation. This will re-write configuration so SAN access will be enabled. If this doesn't help, uninstall the Transporter completely and reinstall it.

Old Version of TLS in ESXi 5.5

Starting from NAKIVO Backup & Replication v7.5, TLS 1.0 which is used by ESXi 5.5, is not supported by default. We recommend updating your vSphere environment to the latest version to avoid using the old TLS. If this solution is not available, create a configuration file on the machine where the source Transporter is installed:

  • Windows - C:\Windows\System32\config\systemprofile\AppData\Roaming\VMware\config.ini
  • Linux - /etc/vmware/config

...