Search

Help

Page 1 of 10. Showing 99 results (0.01 seconds)

  1. Data Size Mismatch

    Product Version: 10.2 Last Modified: 18 December 2020 Problem The backup/replication/backup copy/recovery job fails with the following error. Data size … . Background The error occurs due to a mismatch in the expected data size to be processed and the actual size of the processed data which may result in a VM
    Knowledge BaseDec 29, 2020
  2. Physical Machine Job Fails Due to Unsupported Disks

    with unsupported cluster disks to the product inventory. However, jobs for these machines may fail or contain incomplete data. This is a known issue of NAKIVO
    Knowledge BaseFeb 01, 2021
  3. Disk-Level Job Failure

    details. VM Disk Issues The target VM disk might not exist The target VM could not be changed Host might have failed to write some data blocks to the target VM … Product Version: 9.1 Last Modified: 27 September 2019 Problem VM processing fails. The following error message appears: An error has occurred while backing up
    Knowledge BaseJun 03, 2021
  4. Data on Tape Cannot Be Discovered

    : Data in the (X) tape cartridge cannot be discovered. The (X) tape cartridge block size is different than the block size of the (Y) tape device. Background To access content on all the tape cartridges of a tape library, all tapes should have the same data block size. The above error is displayed when a tape cartridge
    Knowledge BaseJun 04, 2021
  5. Data Transfer Modes

    https://helpcenter.nakivo.com/User-Guide/Content/Overview/Hot-Add-for-VMware.htm?Highlight=Hot%20Add%20for%20VMware transport modes. What VMware data transport modes does NAKIVO Backup and Replication support? Find the answer to the following question in NAKIVO Knowledge
    Knowledge BaseMay 31, 2021
  6. Change Tracking Data Was Not Provided

    Product Version: 8.5 Last Modified: 04 April 2019 Problem An error message states that the source host did not provide valid CBT/RCT/CRT data for a VM … incremental. By default, NAKIVO Backup & Replication uses VMware CBT, Hyper-V RCT, and Nutanix CRT technologies to identify what data has changed since the last job
    Knowledge BaseJun 03, 2021
  7. ESXi Host Did Not Provide Valid CBT Data

    Product Version: 9.0 Last Modified: 27 August 2019 Problem An error message states that the source VMware ESXi host did not provide valid CBT data. Background … http://kb.vmware.com/kb/1020128 technology to identify which data has changed since the last job run. Several factors – such as a power outage – can cause
    Knowledge BaseJun 04, 2021
  8. Using Cartridges Without Barcodes to Read or Write Data

    Product Version: 9.1 Last Modified: 28 August 2019 Question Can I read/write NAKIVO Backup & Replication data from/to a cartridge that has no barcode? Answer Reading/writing NAKIVO Backup & Replication data to/from a cartridge without a barcode can be performed by manually moving this cartridge to the drive of a tape
    Knowledge BaseMay 18, 2020
  9. Physical Machine Agent Installation Failed

    is displayed: Physical Machine Agent installation has failed. Physical Machine Agent cannot be installed on the "X" machine. This machine already contains … installed on it, the PMA installation process fails and you see the above error. Before you proceed with the solution below, make sure that the Transporter is not being
    Knowledge BaseJun 04, 2021
  10. Failed to Connect to Active Directory Domain

    the connection test on the Settings page of the wizard fails with the following error: Could not connect to the AD domain. Possible Causes Some
    Knowledge BaseMay 31, 2021